Logitech QuickCam mod to fit a standard tripod

I have a Logitech QuickCam Communicate Deluxe webcam. It’s a decent webcam apart from the non standard mounting holes. I wanted it to fit a standard tripod so I did some modding. Here is how.

Webcam before mod
Logitechs "flexible clip" - not flexible at all if you ask me...

I started out by splitting the screen clip from the cam. It’s a bit scary but I pulled until it released.

Split clip from cam
Split clip and cam

We will going to use the plastic part with the screws so just unscrew it from the screen clip.

Removed the plastic part from the clip
Removed the plastic part from the clip

A standard tripod is just a 1/4″ screw. I found the following two.

I found the following two 1/4" screws that could work
One of these two could work

Here is how they would look. Not sure what the right one was used for but I think it would be easier to attach to the plastic part so I chose that one.

Trying out my options
Trying out my options

I’ll glue the plastic part with the metallic part so I’ll polish both to make the glue stick better.

Polish to make the glue stick
Polish to make the glue stick

Time to glue. I used a double sided tape but glue would work just as well.

Glue together
Glued together

Put the plastic part back to the webcam attach it to you tripod and we are done.

My modded webcam attached to a Gorillapod
My modded webcam attached to a Gorillapod

Publicerat av

Ola

Mångsysslande doer & klätterentusiast. Jag driver varumärket Sten & bloggen Klätterbilder. Jag konsultar inom IT & Marknadsföring samt undervisar inom webb på Folkuniversitetet. Jag älskar att fota. /// Doer & climbing enthusiast. I run the climbing brand Sten & the blog Klätterbilder. Consulting with IT & marketing & teaching at Folkuniversitetet. I love to take pictures.

En reaktion på ”Logitech QuickCam mod to fit a standard tripod”

Kommentarer inaktiverade.